Not Released
Experience: Works
Not Used
Get This Part
Composite

Part:BBa_K208038

Designed by: USU iGEM 2009   Group: iGEM09_Utah_State   (2009-10-20)

Lac Promoter/RBS/GeneIII/PhaP/Terminator

This is a composite part that was created to demonstrate phasin secretion. The GeneIII signal peptide was fused to the phasin sequence. Both of these parts are Silver-fusion compatible, as discussed on their individual part pages. The lac promoter was used.

NOTE: The scar between the signal peptide and the protein is not presented correctly in the sequence below. The scar is the Silver-fusion scar (ACTAGA), which allows for in-frame fusion. Additionally, the scars before the signal peptide and after the protein are affected by these parts each having the Silver-fusion prefix and suffix.


Usage and Biology

PHA-associated proteins, called phasins, strongly interact with the PHA granule surface (York, 2001; Maehara, 1999). Accordingly, PHA recovery may be possible by tagging the phasin protein for translocation. Specifically, the Silver fusion Biobrick standard can be used to create constructs in which a targeting signal peptide sequence is genetically fused to the phasin protein (Phillips, 2006). Fusing a signal peptide to a protein promotes export of the complex out of the cytoplasm (Choi, 2004; Mergulhão, 2005). The interaction of phasin with PHA is required for secretion-based granule recovery because PHA is a non-proteinaceous compound produced by the action of three enzymes (Suriyanmongkol 2007; Verlinden 2007). Consequently, the signal peptide cannot be directly attached PHA granules. The phasin protein with attached signal peptide binds to PHA granules, thereby creating a PHA-phasin-signal peptide complex that may be recognized by the cell for export.

Sequence and Features


Assembly Compatibility:
  • 10
    COMPATIBLE WITH RFC[10]
  • 12
    COMPATIBLE WITH RFC[12]
  • 21
    COMPATIBLE WITH RFC[21]
  • 23
    COMPATIBLE WITH RFC[23]
  • 25
    COMPATIBLE WITH RFC[25]
  • 1000
    COMPATIBLE WITH RFC[1000]
Phasin PR.jpg

This figure of an SDS gel shows potential phasin secretion. The geneIII secretion signal sequence fused to the phasin protein was expressed in E. coli cells. The E. coli cells were grown overnight in LB growth media and centrifuged to pellet the cells. Supernatants (5ml) were then concentrated using a Centricon Centriplus concentrator (Amicon, Beverly MA). This process concentrated proteins that were larger than 10kDa and removed molecules smaller than 10kDa. Approximately 20ug of protein were then applied to a SDS polyacrylamide gel to separate the proteins according to size. The gel was then stained with coomassie blue for protein detection. Following SDS polyacylamide gel electrophoresis (PAGE) and subsequent coomassie blue staining of the separated proteins, a protein with an approximate size of 22kDA is observed in the sample from the phasin-expressing E. coli cells that is not present in the control E. coli sample. The phasin protein has been reported by others to migrate on SDS PAGE from 14-28kDa (Pötter, 2002; York, 2002). These results indicate that the GeneIII::phasin expression construct is being produced by the E. coli cells and is being secreted outside the cell into the media.

[edit]
Categories
Parameters
None